http://www.metbel.com/2007/07/14/mechanical-seals-faqs/ Sun, 04 Dec 2011 10:25:43 +0000 hourly 1 http://wordpress.org/?v=3.3 http://www.metbel.com/2007/07/14/mechanical-seals-faqs/comment-page-1/#comment-52 ok Thu, 25 Sep 2008 06:35:54 +0000 http://www.METBEL.com/?p=14#comment-52 good site geaiqc good site geaiqc

]]> http://www.metbel.com/2007/07/14/mechanical-seals-faqs/comment-page-1/#comment-26 petermetbel Wed, 02 Jan 2008 08:43:14 +0000 http://www.METBEL.com/?p=14#comment-26 Normally, it is around 6-12 months, depend on conditions of media it seal. Since teflon bellows is outside mounted seal, pressure should not be higher than 10 bar to avoid leakage, from my experience. Peter Normally, it is around 6-12 months, depend on conditions of media it seal.
Since teflon bellows is outside mounted seal, pressure should not be higher than 10 bar to avoid leakage, from my experience.
Peter

]]> http://www.metbel.com/2007/07/14/mechanical-seals-faqs/comment-page-1/#comment-25 ARSHAD Sat, 29 Dec 2007 16:54:55 +0000 http://www.METBEL.com/?p=14#comment-25 what is the life of seal face of teflon below seal.how much pressure is sufficent to avoid leakage. what is the life of seal face of teflon below seal.how much pressure is sufficent to avoid leakage.

]]> http://www.metbel.com/2007/07/14/mechanical-seals-faqs/comment-page-1/#comment-2 G.A.Kulkarni Thu, 02 Aug 2007 10:00:37 +0000 http://www.METBEL.com/?p=14#comment-2 Looking for split Mechanical seals for following duty parameters. Hydrate slurry. % solids 30% by volume. Sp Gr 1.53. Temp 60 Deg C. Liquor content : NaOH.(Caustic) Concentration : 225 Gpl. Pump Pressure Suction 1.5 Kg /Sq cm Delivey 4.o Kg/Sq cm Shaft dia 115 mm. Grease dispenser. Looking for split Mechanical seals for following duty parameters.
Hydrate slurry.
% solids 30% by volume.
Sp Gr 1.53.
Temp 60 Deg C.
Liquor content : NaOH.(Caustic)
Concentration : 225 Gpl.
Pump
Pressure Suction 1.5 Kg /Sq cm
Delivey 4.o Kg/Sq cm
Shaft dia 115 mm.
Grease dispenser.

]]>